Friday 4 March 2011

A pine model of the strycsitten

I showed the plan for the construction in one of my previous posts, but I was not sure if it would work. I decided to make a full-scale model in cheap pine wood to test the construction, before I would make it in expensive European oak. The only size adjustment I made was reducing the length of the strycsitten to half (70 cm) of that of the plan, creating an oversized chair (or more modern, a love-seat) . Furthermore, the panels on the sides and the triangles were left plain and undecorated. The next series of photos shows the construction of the pine model in steps. 


 
These five photos show the layout of one of the several parts of the side of the strycsitten. Note the grooves for the panels and the triangles


 The triangles first have to be put into the grooves of the horizontal rail, as they also form part of the tenon, before they can be added to the legs of the strycsitten.



After that, the mid stile and the two panels were added to the constructed 'H', then the plank of the armrest finished the side of the strycsitten. I discovered later that the mid stile had to be fixed first to the horizontal rail (using dowels), then the panel added and after that the legs, and finished with the arm rest. This is because the panels also form part of the tenons of the mid rail and the legs.




The other parts were added in the same manner. Note that the long middle rail has the tenon 90 degrees turned ( photo on the right).





The framework is finished (left). The seating planks have to be adjusted for the sides of the strycsitten by removing some pieces (centre). Finally the backrest was added (right).





The finished model of the strycsitten. No dowels have been used yet to fix the parts (except for the backrest), as I wanted to be able to de-construct the model if needed.

No comments:

Post a Comment